Rajgranth Metal & Alloys exports welded pipes to Malaysia from Mumbai in SS 202, 304, 316, duplex and nickel alloy grades, shipped to Port Klang or Penang with an EN 10204 3.1 mill certificate. Typical buyers are process equipment builders, food and palm oil plant contractors, fabricators and distributors.
Malaysian demand comes from oil and gas, palm oil processing, food and beverage, chemicals, the electronics and semiconductor cluster around Penang, and construction.
A hot, humid, equatorial climate with coastal salt on both sides of the peninsula. Palm oil and food plants add washdown with cleaning chemicals, which is hard on lower grades. Food, palm oil and washdown service calls for 304L, 316L or duplex rather than 202. SS 202 is used for indoor furniture, decorative work and light fabrication.
Malaysian Standards (MS) exist, but projects commonly specify ASTM, ASME, BS or EN, and oil and gas work follows operator and API requirements. Buyers in the region typically order coils, sheets, welded pipe and tube in 202 and 304, polished or in 2B finish.
Welded pipe is formed from flat strip, seam-welded and then usually annealed or dressed. It is the economical route for larger diameters and for decorative and structural pipe, and it is the form in which SS 202 is most often bought.
Welded pipe is formed from strip and seam-welded, then solution annealed and pickled. For ambient and moderate-pressure duty — water, structural, food and general process lines — it delivers the same corrosion performance as seamless at materially lower cost, and is available in larger diameters.
mm
SWG, mm
Customised up to 12 m per requirement
All welded pipes: grades, standards and finishes →SS 202 composition and properties →
State the grade, size, quantity, standard and destination port. We will confirm availability, documents and the Incoterm for Malaysia.
